|
|
X-ray observations of tungsten wire array Z-pinch implosions on QiangGuang-1 facility
章法强, 李正宏, 许泽平, 徐荣昆, 杨建伦, 郭存, 夏广新, 陈进川, 宋凤军, 宁家敏, 王真, 薛飞彪, 李林波, 秦义, 应纯同, 刘广均
2006 (9):
2058-2064.
doi: 10.1088/1009-1963/15/9/028
摘要
(
1598 )
PDF(728KB)
(
784
)
Z-pinch experiments with two arrays consisting, respectively, of 32
4-μm- and 6-μm-diameter tungsten wires have been carried out on
QiangGuang-1 facility with a current rising up to 1.5MA in 80ns. At early
time of implosion, x-ray framing images show that the initial emission comes
from the central part of arrays, and double clear emission rings, drifting
to the anode and the cathode at 5×106cm/s and 2.4×107cm/s respectively, are often produced near the electrodes. Later,
in a 4-μm-diameter tungsten wire array, filamentation caused by ohmic
heating is prominent, and more than ten filaments have been observed. A
radial inward shift of arrays starts at about 30\,ns earlier than the
occurrence of the x-ray peak power for both kinds of arrays, and the
shrinkage rate of emission region is as high as 1.7×107cm/s in
a 4-μm-diameter tungsten wire array, which is two times higher than
that in a 6-μm one. Emission from precursor plasmas is observed in
implosion of 6-μm-diameter tungsten wire arrays, but not in implosion
of a 4-μm-diameter tungsten wire array. Whereas, in a 4-μm-diameter tungsten wire array, the soft x-ray emission shows the growth of
m=1 instability in the plasma column, which is caused by current. The
reasons for the discrepancy between implosions of 4-μm- and 6-μm-diameter tungsten wire arrays are explained.
相关文章 |
计量指标
|